We service both gas and electric furnace systems with manufacturer-trained technicians.
Heat exchanger cracks, ignitor failures, and gas valve issues all fall within our scope.
Furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other hvac repairs don't, so the diagnostic has to start there, which is exactly why furnace repair calls in Hillsboro, OR get treated with urgency, not a next-available-Tuesday slot.

Most furnace repair problems give some warning before they turn into a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air — catching it early usually means a shorter, cheaper fix.
AAA Pro HVAC built its furnace repair process around one idea: diagnose first, quote honestly, fix it right.
Every truck across Hillsboro, OR carries the tools and common parts specific to furnace repair, so most calls finish in a single visit.

Cracked heat exchangers get flagged immediately as a safety issue, not just a repair line item.
Our crews are trained on standing pilot, hot surface ignition, and electric resistance furnace systems alike.
No push toward replacement when a repair genuinely solves the problem.
We understand a dead furnace in winter is a pipe-freezing risk, not just a comfort issue.
From the first symptom to the final fix, these are the specific furnace repair services our Hillsboro-area crews are equipped for.
Standing pilot systems get checked for thermocouple failure, the most common cause of a pilot that won't hold. This is one of the most requested furnace repair calls we get across Hillsboro, OR.
A gas valve that won't open or won't seal is tested with proper manometer readings, not just listened to. This is one of the most requested furnace repair calls we get across Hillsboro, OR.
We use a combustion analyzer and visual borescope inspection, not guesswork. This is one of the most requested furnace repair calls we get across Hillsboro, OR.
A furnace that runs but never blows warm air often traces to a blower motor or limit switch fault. Techs handling blower motor & limit switch repair carry the specific parts and tools this job calls for, not a generic kit.
We inspect the full flue run, not just the connection at the furnace. This is one of the most requested furnace repair calls we get across Hillsboro, OR.
A furnace that won't respond to the thermostat at all sometimes traces to a control board fault rather than the burner assembly. This is one of the most requested furnace repair calls we get across Hillsboro, OR.

Tell us the symptom — no ignition, cold air, gas smell, or error code — and we route accordingly.
We confirm your Hillsboro address and a realistic arrival window.
Flat-rate quote follows the confirmed fault, before repair begins.
Heat exchanger findings are documented clearly regardless of outcome.

Tech tested the ignitor's resistance right in front of me and swapped it in under thirty minutes.
Old furnace was blowing cold air even though the blower ran fine.
Shut the furnace down immediately for safety and walked me through the options.
Pilot light kept going out every few hours.

Usually a failing ignitor or a fouled flame sensor — both are testable with the right equipment rather than replaced blind.
Yes — it's a genuine carbon monoxide risk and we treat it as a safety issue, not a routine repair line.
This symptom shouldn't be ignored since it sometimes points to a safety-related fault.
Yes — our technicians are trained and certified on both fuel types.
Immediately — leave the area and call, don't attempt to diagnose it yourself.
No-heat calls during freeze warnings are prioritized across Hillsboro, OR.

Whether you're in the heart of Hillsboro or one of the surrounding communities, dispatch routes the closest available technician.
☎ Call +1-866-805-8548 for Hillsboro Service